Calculation sequence
Step-by-step method
- Calculate dry-air mass flow.
- Subtract leaving from entering humidity ratio.
- Multiply dry-air mass flow by humidity-ratio decrease.
MechanicalIntermediatePsychrometrics
Condensate Generation Calculator
Calculate airside condensate generation from dry-air mass flow and humidity-ratio decrease.
Why it matters: Condensate rate supports drain, pan, pump, and field-performance evaluation.
Calculated result
Engineering evaluation
Estimated condensate generation (ṁc)180 lb/h
- Dry-air mass flow (ṁda)
- 45,000 lb/h
- Humidity-ratio decrease (ΔW)
- 0.004 kg/kg dry air
Engineering interpretation
The entered dehumidification condition produces approximately 180 lb/h condensate.
Important limitations
- Drain sizing must consider transient peaks, carryover, cleaning, pan geometry, trap pressure, lift, safety factors, and local requirements.
Engineering knowledge center
Understand the calculation—not just the answer
Governing relationships
ṁda = ρQ×60
ΔW = W1−W2
ṁc = ṁda·ΔW
Current substitution
ṁda = 45000; ΔW = 0.012−0.008 = 0.004; ṁc = 180 lb/h.
Equation legend
Inputs and calculated quantities
- Q
- Dry-air volumetric flow — cfm or m³/s
- ρ
- Dry-air density — lb/ft³ or kg/m³
- W1
- Entering humidity ratio — lb/lb or kg/kg
- W2
- Leaving humidity ratio — lb/lb or kg/kg
- ṁc
- Estimated condensate generation — lb/h
- ṁda
- Dry-air mass flow — lb/h
- ΔW
- Humidity-ratio decrease — kg/kg dry air
Applications
How this calculation is used
Building design
Screen condensate generation at a cooling/dehumidification condition.
Construction
Check drain and pump duty basis.
Commissioning
Estimate field condensate rate from airflow and psychrometric states.
Quality controls
Assumptions and limitations
Assumptions
- Entered values represent one stable operating condition and use consistent measurement boundaries.
- Fluid and air properties are representative of the evaluated condition.
Limitations
- This is a preliminary evaluation and field-verification tool, not a final sizing or code-compliance determination.
- Manufacturer data, adopted codes, project criteria, and professional engineering review remain controlling.
Field use
Verification procedure
- Confirm measurement boundaries, operating mode, and instrument calibration.
- Stabilize the system and record simultaneous readings.
- Compare the calculation with project requirements and manufacturer data before disposition.
Common engineering mistakes
- Mixing values from different operating conditions.
- Using nominal rather than measured flow, temperature, power, or fluid properties.
Technical basis
References and source standards
- ASHRAE Handbook—FundamentalsPsychrometrics, heat transfer, load relationships, and HVAC calculation context; verify the licensed current edition during professional review.
- NIST Guide for the Use of the International System of UnitsFederal unit-system and conversion reference used for SI/I-P presentation.
Engineering calculation disclaimer
These engineering tools are provided for educational, preliminary evaluation, field verification, and commissioning support. Results depend on the accuracy of user-entered information and the assumptions stated for each calculation. Every colored status and comparison is a screening indicator only; project criteria, contract requirements, applicable codes, manufacturer instructions, measurement uncertainty, and authorized engineering judgment govern. The tools do not replace project-specific engineering analysis or the judgment of a licensed professional engineer.
Read the full use and limitation statement